Overview

Introduction

The Configure and Verify PPP on WAN Interfaces module provide you with the instructions and Cisco hardware to develop your hands on skills in configuring the Point-to-Point Protocol over WAN interfaces. This module includes the following exercises:

  • Configuring a point to point link using HDLC and PPP
  • Configuring PPP authentication over a WAN link

Exercise 1 - Configuring a Point-to-Point Link

In this exercise, you will perform the tasks required to configure a simple point-to-point WAN link between two routers.

In the lab, NYEDGE1 and NYEDGE2 are joined together via their Serial 0/0/0 interfaces with a back-to-back DTE-DCE serial cable. This type of cable is used to recreate the same conditions you would meet in the real world when configuring a WAN link between two sites.

Exercise 2 - Configuring a Point-to-Point Link using PPP

In this exercise you will perform the tasks required to configure an authenticated Point to Point Protocol, or PPP connection between two Cisco routers.

Comprehensive Learning

See the full benefits of our immersive learning experience with interactive courses and guided career paths.