Configure and verify PPP
The "Configure and verify PPP" module provides you with the instructions and Cisco hardware to develop your hands on skills in configuring PPP authentication and PPPoE, this module contains the following exercises: 1. Configure and verify PPP authentication, 2. Configure PPPoE.

Introduction
The Configure and verify PPP module provides you with the instructions and Cisco hardware to develop your hands on skills in configuring PPP authentication and PPPoE, this module contains the following exercises:
- Configure and verify PPP authentication
- Configure PPPoE
Exercise 1 - Configure and verify PPP authentication
In this exercise you will configure an authenticated PPP connection between NYEDGE1 and NYEDGE2 as shown in the diagram below. There is a back-to-back serial cable connecting NYEDGE1 and NYEDGE2 between their Serial0/0/0 interfaces.
Exercise 2 - Configure PPPoE
In this exercise you will configure PPPoE on NYEDGE2 to create an additional connection between the two routers. In the diagram below you can see there is a connection between NYEDGE1 and NYEDGE2 Gi0/2 on both routers, this will be used to create the PPPoE connection.
See the full benefits of our immersive learning experience with interactive courses and guided career paths.